It even works with the wired nic disabled and the ip address of the wireless set to 2.0.0. This keeps working even with the windows firewall and the wireless connection active and a loopback connector connected to the wired nic. I also tried anothe Art-Net listener being the Luminex Wygalizer (whitch is probably not as strict) that interfaces with Wysiwyg visualization software and this works perfectly providing I start FS first and than the Wygalizer. Now I am wondering could it be that the Art-Net tool must be on a different pc? I have not yet tried this, since right now I only have 1 pc (expecting to get one in a couple of months) I have the windows firewall running (turning it on or off did not change anything in the above behavior)ĭisabling my wireless connection also did not change the above behavior. These features are all programmed via DMX-Workshop or the gateway’s web browser. The action can be to ‘hold last state’ which is the default, or playback a preset scene. This means that you can program what the gateway should do in the event of network failure. (although it did the same with an ethernet loopback connector) The majority of Artistic Licence receivers. I have it all running on one laptop (win xp) with 2 network interfaces: one wireless (that connects to my wireless router at a local ip address) and one wired, which I also connected to my router and gave a fiwed ip address of 2.0.0.1. If you then start up FS, the latter just does not send anny packet at all. If you do it the other way around and start up the Art-Net to DMX tool first, that one starts up ok. If you then start the Art-Net to DMX tool, the latter gives an error saying: Address 0 in use and when you click ok, it says: Interface error I figured out that when you start FS (with the Art-net interface selected) it starts sending out Art-Net packets. I have did som more tries and used an ethernet packet sniffer and got it (partionally) working. I have checked the blackout and freeze settings and also the master (whitch is at 100%). It seems reestyler is not sending out any Art-Net packet. I think my network setup is ok, because when I start Dmx Workshop (from Artistic License) I can change the output values in Art-net to DMX tool perfectly. When I open the edit/Show Output I get a window with 6 output values that are responding to the sliders on the right of Freestyler, but the Art-Net outputs remain at zero. When I open the Art-Net to DMX tool, It says:īut when I open the show output dialog, the values stay at zero. I use a 6-bar of PAR64's starting at dmx address 1. I have chosen the Art-Net interface with universe 0 in the Freestyler setup. I have my laptop connected to a network router and my nic's IP address is 2.0.0.1 subnet mask: 255.0.0.0 I am trying to set up Freestyler to run on Art-Net interface, but it does not seem to work. I am new to Freestyler so maybe my problem is trivial but annyway.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |